Saturday 9 January 2016

New Keys - Registering keys with HISS.


My engine came from a crashed bike so I only got the one bent key that must have been in the ignition at the time of the crash.

I was going to send off the ECU to a chap who can program blank keys from your ECU but he wants £200 to program two keys.

I have ordered the following from this Ebay Seller . £40 quid, a good £160 saving!

Two blank keys.


And a special loom to program the keys.




Method is...  (with your new cut keys)

1. Disconnect the 2 pin wiring from the CKP sensor.
2. Connect the special wiring loom.
3. Connect the positive and negative leads to the battery.
4. Using original Key, turn the ignition on.
5. Disconnect the positive battery connector for 5 seconds then reattach.
6.  The HISS light (if you have one) should come on for 2 seconds and flash 4 times.
7. Turn off ignition and remove original key. Move well away from the HISS sensor.
8. Inset the new key and turn on the ignition. The HISS light will come on for 4 seconds and then flash 4 times. This means a the new key is registered.
9. Turn off ignition, and repeat for each new key.
10. Turn off ignition, remove special wiring loom and reconnect CKP sensor.


Once it all turns up I will make sure it works as above.





No comments:

Post a Comment